11
4.
Press and hold the Volume key on the original transmitter. Release the key
when the indicator light gives a green light. This might take up to 10 seconds.
If the indicator light
B
goes orange press one or several times again until it
flashes green and the indicator light
B
flashes red. When the indicator light
A
flashes red the programming is complete.
5.
Repeat steps 3 to 5 until all keys are programmed. Finish by pressing key 10
for 2 seconds. Insert the label and put on the keyguard. If the programming
was not successful start from the beginning. The earlier programming is
erased as soon as a new programming starts.
Tip 1:
Control TV can learn channels from most IR transmitters on the market
with a few exceptions. You may have problems with a few or all of the functions
for a certain IR transmitter. In these cases it is possible to try another recording
method. Instead, do as follows in step 2; Press
P
and
1
at the same time but keep
them pressed for approximately 2 seconds until the indicator light
B
for
programming flashes green and goes out. The indicator light
A
now flashes red.
Control TV is now in another recording mode. Otherwise use the same
recording procedure.
Tip 2:
It might be of importance how long the key on the original transmitter is
pressed. If it is impossible to program a key try to press long short, short short,
long long or short long. See point 4.
B
A
