G3 – Owner‘s Manual | 85
11.2.6
P
ARAMETER
D
ETAIL
–
M
ULTI
FX
MENU
[F3]
[MULTI FX]
[F1]
Multi FX - Parameter
Multi Effects – Mutual Parameters
Parameter
Value Range
Description
Level
%
Adjusts the balance between Dry and Wet = On/OFF signal sent to the mixer.
Send to Room Reverb
%
When Room Reverb is active, Multi Effects can sound self-sufficient and out of
place. With this parameter, you can add room sound to a multi-effect for an
integrated sound of the drum kit.
A low value reduces the room component, while a high value emphasises the room
component in the mix.
Note
These parameters are not part of the preset management but are stored as drum kit parameters using the
direct method (save the drum kit).
Wah-Wah
Parameter
Value range
Unit
Description
Filter Type
Low Pass, Band
Pass
Choose between a high cut filter (low pass) or band pass bell filter.
Underlying constants:
Transition steepness: 12 dB (Low Pass)
Frequency
100Hz - 8kHz
Hz
Depending on the selected filter type, this parameter sets the centre
frequencies of low pass or band pass for the stroke velocity value of 0
(starting point).
Resonance
0-127
Corresponds to the "Q" factor in equalization. This parameter controls
the width of the bell filter shape (band pass) and in case of selecting the
low-pass option, Resonance controls the bell shape of the "overshoot-
ing" at the filter frequency. Set the width of the bell filter shape from 0
(no resonance, wide) in the lowest control position to 127 (max reso-
nance, narrow) in the highest control position.
Sensitivity
0-100
%
Sensitivity defines the degree to which the dynamics of a stroke on a
pad (Velocity) may control the movement of the specified filter along
the possible frequency spectrum. The filter is defined by the parameters
Filter Type, Start Frequency and Resonance.
Technically, Sensitivity works as a multiplier (attenuator) for the effect
intensity at a specific stroke velocity level.
Example: With a sensitivity of 50%, a stroke on a pad with a maximum
velocity of 127 causes the filter to move only halfway along the possible
frequency range in the specified direction, while the same stroke
velocity with sensitivity of 100% would exhaust the full frequency
spectrum possible.
The values range from 0 (off) to 127 (100%).
Direction
Up, Down
Set the direction of movement for the filter type in the frequency
spectrum starting at Frequency.
