48
|G5 – Owner’s Manual
DYN LEVEL & DYN TIME
Dyn Level
determines how hard the G5 tries to suppress false triggers, whereas
Dyn Time
deter-
mines how long false triggers are suppressed. For most pads with rubber playing surfaces,
Dyn
Level
values between 8 and 15 and
Dyn Time
between 8 and 20 should give the best results. For
pads with fabric heads, it may be necessary to increase
Dyn Time
to over 20 and up to 60 as the
skin diameter increases.
Dyn Level Parameter Value range:
0-15
Dyn Time Parameter Value range:
0-60 ms
12.1.2
X-T
ALK
X-Talk is a tool to avoid unwanted signals in other pads.
Vibrations can trigger the triggers of other instruments. With X-Talk, you can set a threshold for other
triggers, above which they will only react to vibrations in the environment.
Velocity values below this threshold are ignored by the analysis unit (G5 module). This practice
comes at a price, however, as the physical effects of two instruments on each other are usually
mutual. High X-Talk thresholds counteract low activation thresholds of individual pads (for sensitive
players) and any physical problem often requires an increase in X-Talk values on both instruments
causing the problem. Check your hardware first and try to avoid physical contact as much as
possible before using the X-Talk function.
TRIGGER SETTINGS
[F1]
[F1]
X-Talk
SETTING UP X-TALK
If, despite the best possible hardware setup, a pad is receiving interference signals from other
pads, first try to identify the pad that is causing the interfering MIDI signals using the X-Talk monitor.
Then increase the X-Talk value on both pads to at least 1 (causing pad and receiving pad). If the
problem persists, gradually increase the value on the pad that is receiving unwanted signals. It is
important that both pads have X-Talk values of at least 1 to make them a member of the X-Talk
group. High X-talk values on pads experiencing interference will have no effect unless there is at
least one other connected pad with an X-talk value of at least 1. Only increase the X-talk values
on the pads that are experiencing problems. To suppress viral MIDI signals, the goal for X-talk
values is: as low as possible, and only as high as necessary.
Summary of Contents for G5
Page 32: ......
Page 147: ...G5 Owner s Manual 133 376Ch Tap Head Rim 2nd MIDI note 0 not used 0 ...
