68
|G5 – Owner’s Manual
Wah-Wah
Parameter
Value range
Unit
Description
Filter Type
Low Pass,
Band Pass
Choose between a high cut filter (low pass) or band pass
bell filter.
Underlying constants:
Transition steepness: 12 dB (Low Pass)
Frequency
100Hz - 8kHz
Hz
Depending on the selected filter type, this parameter sets
the centre frequencies of low pass or band pass for the
stroke velocity value of 0 (starting point).
Resonance
0-127
Corresponds to the "Q" factor in equalization. This parameter
controls the width of the bell filter shape (band pass) and in
case of selecting the low-pass option, Resonance controls
the bell shape of the "overshooting" at the filter frequency.
Set the width of the bell filter shape from 0 (no resonance,
wide) in the lowest control position to 127 (max resonance,
narrow) in the highest control position.
Sensitivity
0-100
%
Sensitivity defines the degree to which the dynamics of a
stroke on a pad (Velocity) may control the movement of the
specified filter along the possible frequency spectrum. The
filter is defined by the parameters Filter Type, Start Frequency
and Resonance.
Technically, Sensitivity works as a multiplier (attenuator) for
the effect intensity at a specific stroke velocity level.
Example: With a sensitivity of 50%, a stroke on a pad with a
maximum velocity of 127 causes the filter to move only
halfway along the possible frequency range in the specified
direction, while the same stroke velocity with sensitivity of
100% would exhaust the full frequency spectrum possible.
The values range from 0 (off) to 127 (100%).
Direction
Up, Down
Set the direction of movement for the filter type in the
frequency spectrum starting at Frequency.
Summary of Contents for G5
Page 32: ......
Page 147: ...G5 Owner s Manual 133 376Ch Tap Head Rim 2nd MIDI note 0 not used 0 ...
