72
|G5 – Owner’s Manual
Delay
Parameter
Value range
Unit
Description
Type
Mono, Stereo
Mono produces a mono signal that is audible at both speakers
simultaneously. In stereo mode, the delayed signals alternate
between the left and right speakers. The mono signal is shifted to
the left speaker and the second signal for the stereo effect is
inserted between the mono signals on the right speaker. This dou-
bles the feedback frequency (delay time is halved).
Delay Time
0-1365
ms
Controls the time in between repeats.
Feedback
0-127
Controls the number of repeats until the effect fades out. Select low
fader positions for fewer repetitions and high fader positions for lots
of repeats.
Pre-Low-Pass
2-8
kHz
Cuts the high frequencies of the dry signal above the set cut
frequency. Only frequencies below the threshold frequency are
passed on to generate the effect. The slope steepness of the filter is
12 dB.
Pre-Low-Pass is only applied to the delayed sound. The dry signal
itself is not affected.
High Damp
0-100
%
Filter that causes the high reverb frequencies to decay faster than
the rest. The slider ranges from 0% (no attenuation) to 100% (maxi-
mum attenuation). Select higher values to create a delay that
makes it seem as if the sound is moving away from the ear, while
low damping values cause the repetitions to stagnate near the Dry
signal.
Summary of Contents for G5
Page 32: ......
Page 147: ...G5 Owner s Manual 133 376Ch Tap Head Rim 2nd MIDI note 0 not used 0 ...
