8
HC14 | HC14-AC | HC14-T - Owner´s Manual
En
gli
sh
De
u
ts
ch
Če
sky
Es
p
añ
o
l
Fran
çais
Itali
an
o
Po
ls
ki
Po
rt
u
gu
ês
Height adjustment top cymbal (GEWA System)
For the use with GEWA factory Trigger Banks the top cymbal needs to be mounted high enough, so that the
Clutch Bumper (E) does not press down the controller shaft (O). See
for comparison.
Figure 5
Figure 6
1
Lift the top cymbal gradually, until the carriage of the Hi-Hat Controller (O) stops following the
movement.
2
In this position, fasten the clutch wing screw (N) as shown in
3
After step 2, the Clutch Bumper (E) should be touching the carriage Hi-Hat Controller (O), without
pressing the shaft down (see
). This corresponds to a minimum cymbal spacing (S) of approx-
imately 19 mm (¾”).
4
(Optional) Repeat steps 1-3 with a higher position of the top cymbal for wider cymbal spacing.
Note
GEWA Drum Consoles:
Cymbal spacing below the minimum (S) is possible but requires adjusting
the trigger parameter “
High Position
” (Hi-Hat Controller). For more information, please refer to the
section
Trigger Settings
in the owner´s manual of your GEWA drum console.
5
T
RIGGER
S
ETTINGS
Having set up the hardware along the lines described in this document, proceed with the trigger
settings in your drum module. The operation with GEWA Consoles requires loading the Trigger Bank
shown below. Regarding other manufacturers, please take note of the hints given.
GEWA consoles
Other manufacturers*
Trigger Bank:
GEWA HH14
Input Channel:
Hi-Hat
(See owner´s manual of your GEWA console for more
information about loading trigger banks)
Check first whether your drum module supports
the trigger types (Sensors) built into GEWA pads.
Check whether the manufacturer of your module
offers a trigger bank for the GEWA pad you want
to connect.
Consult the owner´s manual of your drum module
for Information about trigger setups, accessible
parameters and customization of 3
rd
party
equipment.
Note
*Although GEWA cymbals are manufactured to meet industry standards of analogue trigger sys-
tems, GEWA does not guarantee flawless functioning with equipment of other manufacturers. The
operation of this product with 3rd party equipment is at your own risk. If you still decide to operate
this product with 3rd party drum modules, please take first note of the hints above.
Summary of Contents for GD835213
