IQ lock AUT, EL / EL DL, EM / EM DL, C / C DL, M / M DL
5
Safety notices
à
Warranty claims will be rendered invalid if the lock is not repaired by GEZE or an authorised GEZE service partner.
à
GEZE only guarantees that safety requirements are met if genuine GEZE spare parts are used. Faulty
components may only be replaced by genuine parts.
à
GEZE self-locking panic locks must not be opened.
1.3 Safety-conscious working
Work on the electrical equipment (IQ AUT, IQ lock EL, IQ lock EL DL, IQ lock EM, IQ lock EM DL, IQ lock C,
IQ lock C DL) may only be performed by a qualified electrician.
Locks may only be installed by a specialist from the respective trade (locksmith, carpenter etc.).
Only genuine GEZE spare parts or accessories approved by GEZE may be used.
Please contact GEZE for information about the later connection of further accessory parts.
à
Remove the lock before drilling the fixing points for the sliding fitting systems.
à
Do not put any greases, lubricants or oils in the lock. Avoid water penetrating the lockcase or the formation of
condensation.
à
Only use lubricants approved by GEZE for lubricating the outer parts (crossbar, latch), see chapter 1.4.
à
Never paint or varnish over the lock face plate or any other parts of the locks.
à
Remove the lock before doing any painting work.
à
The handle pin must not be forced through the lock follower.
à
The door leaf must not be carried by the handle.
1.4 Cleaning and care
GEZE self-locking panic locks may only be oiled or greased using lubricants approved by GEZE.
Lubricant
Manufacturer
Note
Klübersynth LI 44-22
Klüber Lubrication
Slightly wet the latch and crossbar
Fin Lube TF
Interflon
Spray onto the latch and crossbar from the
outside
1.5 Accessories
GEZE self-locking panic locks may only be used with the accessories prescribed by GEZE.
X
Only use genuine GEZE accessories.
à
If other parts are attached or installed, any warranty, guarantee and/or product liability claims will be
rendered invalid.
1.6 Assembly and installation
Some safety rules must always be observed during fitting and installation of the self-locking GEZE panic locks.
These must be noted and followed, since the device can otherwise be damaged and result in hazards for the user:
X
When installing the locks, make sure you following building regulations and any specifications issued by the
door manufacturer.
à
The lock must not be modified in any way.
à
Lock and original strike plate (1-leaf) as well as lock and original strike box (2-leaf) form one unit. Perfect
function is only possible in combination.
à
If installation is faulty or improper, all manufacturer guarantee and liability claims will be rendered invalid.
1.7 Use of motor locks IQ lock EL/IQ lock EL DL on fire and smoke protection doors
GEZE motor locks, IQ lock EL for 1-leaf and IQ lock EL DL for 2-leaf fire and smoke protection doors may be used
in all modes of operation (permanently unlocked, secured by day, night).
It must be guaranteed that in the event of a fire in the case of the modes of operation “permanently unlocked”
and “secured by day” the electrical activation of the lock is no longer possible, the lock can no longer be
unlocked and the cross latch and bolt engage securely in the locking plate at all times.
Summary of Contents for IQ lock AUT
