IQ lock AUT, EL / EL DL, EM / EM DL, C / C DL, M / M DL
4
Safety notices
à
They are not designated for use on double-action doors.
à
Use in transport technology (pedestrian traffic and transport of goods by road, rail, air and water) must be
agreed with the manufacturer.
The product should be installed or incorporated in such a way that effortless access to the product is guaranteed
during any repairs and/or maintenance, and that any removal costs do not stand out of proportion to the value of
the product.
Trouble-free functioning of the locks is only ensured if a carry bar and a door closer system in accordance with EN
1158 with closing sequence control are mounted.
Before mounting the emergency exit locks ensure that the door is fitted properly and not distorted in any way.
X
Install the emergency exit locks only in hollow doors that are designed for this purpose by the manufacturer.
The horizontal bar must be mounted in such a way that the greatest possible effective bar length is achieved.
X
Avoid safety risks during the installation of emergency exit devices with handle operation (in particular in case
of doors with graded surfaces: jamming of fingers or clothes).
X
If appropriate, adapt installation to the majority of the users:
à
Installation height for children less than 900–1000 mm
à
Door closer installation so that children, elderly or impaired persons are not impeded
Only devices conforming to standard may be used for keeping emergency exit and panic exit doors closed.
Only spring-supported door handles may be used.
In correlation with the specifications of German building regulation laws, a lock of the VS-type A in accordance
with DIN EN 179 or DIN 1125 (lock only for 1-leaf doors) can also be used in the active leaf of a 2-leaf door if:
a) the passive leaf lock is secured against maloperation and
b) the passage clearance of the active leaf is sufficient for an escape route.
1.2 Technical safety
à
Improper installation and maintenance work or repairs can lead to significant hazards for the user. Installation
and maintenance work or repairs may only be carried out by GEZE and their authorised specialists.
à
Damage to GEZE IQ locks can endanger your safety. Check them for visible signs of damage. Never put a dam-
aged lock into operation.
à
Warranty claims will be rendered invalid if the lock is not repaired by GEZE or an authorised GEZE service
partner.
à
GEZE only guarantees that safety requirements are met if genuine GEZE spare parts are used. Faulty compo-
nents may only be replaced by genuine parts.
à
GEZE self-locking panic locks must not be opened.
1.3 Safety-conscious working
Work on the electrical equipment (IQ AUT, IQ lock EL, IQ lock EL DL, IQ lock EM, IQ lock EM DL, IQ lock C,
IQ lock C DL) may only be performed by a qualified electrician. For further information see “Instructions for elec-
trical connection and putting into service”, ID No. 156328.
Locks may only be installed by a specialist from the respective trade (locksmith, carpenter etc.).
Only genuine GEZE spare parts or accessories approved by GEZE may be used.
Please contact GEZE for information about the later connection of further accessory parts.
