Powerturn
11
Operation
Which switch/button?
What does the switch/button do?
Double push button
In the case of 2-leaf drives, a button with a double function
can be connected via a configurable push button. This
means that 1-leaf or 2-leaf opening is possible by pressing
the push button.
If the push button is pressed once, only the active leaf
opens and closes after the hold-open time has expired. If
the button is pressed twice within 1.5 s, both leaves open
and close after the double leaf hold-open time has expired.
Emergency lock
When the emergency lock is used, a switch can close the
1- or 2-leaf system immediately. The doors close with the
set force and without sensor strips and obstacle detection.
There is an increased risk of injury.
WC control
The door opens after the elbow switch on the outside of
the toilet has been pressed, and closes automatically after
the set hold-open time has passed.
When the push button is activated inside the toilet cabin, the
system is switched to the exit only mode of operation, which
means the outer push button no longer opens the door. At
the same time, the lights indicate that the toilet is occupied.
The electric strike is supplied with current, preventing
manual opening of the door from outside.
Activating the “inner” push button again or through manu-
al opening from inside, the WC function (exit only mode of
operation) is cancelled and the drive switched back to the
automatic mode of operation.
The ‘occupied’ displays and lights go out.
4
Operation
The set parameters of the drive functions may only be modified by a service technician.
4.1 Selecting the mode of operation
4.1.1 Selecting the mode of operation using the operating modes push button
The operating modes push button can be deactivated by a service technician.
Changing the mode of operation (with single-leaf doors or active leaf)
X
Press the operating modes push button (21) with operating modes
display briefly.
The operating modes display (2) immediately switches one mode of op-
eration further. The drive itself does not change the mode of operation to
the new mode of operation until 1 s after the last button has been pressed.
Operating modes sequence, with the colour of the operating modes
display in brackets:
…
OFF (–)
Night mode (red)
Exit only (white)
Automatic (green)
Hold open (blue)
OFF (–)
Night mode (red)
…
Thanks to the 1 s delay it is possible to change the mode of operation
from automatic through hold open to night mode without the door
opening in the hold open setting.
Changing the mode of operation (with passive leaf)
X
Press the operating modes push button (21) with operating modes display briefly.
The drive on the passive leaf is switched on and off.
If the drive is switched on, the operating modes display lights up in the colour of the mode of operation (see chapter 3.4.1).
If the drive is switched off, the operating modes display does not light up.
