Powerturn
6
Fundamental safety precautions
2
Fundamental safety precautions
For the user
Carefully read and abide by this user manual before commissioning the door. Always observe the following safety
instructions:
à
Operating, maintenance and repair conditions specified by GEZE must be observed.
à
The commissioning, prescribed installation, maintenance and repair work must be performed by properly
trained personnel authorised by GEZE.
à
The connection to the mains voltage must be made by a professional electrician.
à
No changes may be made to the system without prior agreement from GEZE.
à
GEZE shall assume no liability for damage caused by unauthorised changes to the system.
à
The owner is responsible for safe operation of the system.
à
Have a service technician check the safe operation of the system at regular intervals.
à
Should safety devices be misaligned, thus preventing them from fulfilling their intended purpose, further
operation is not permissible. The service technician must be informed without delay.
à
Make sure that the safety stickers are attached visibly to any glass leaves and are in a legible state.
à
Protect the programme switch against unauthorised access.
à
Danger of injury by sharp edges on the drive when removing the cover
à
Danger of injury by parts hanging down
à
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
à
Children shall not play with the appliance.
à
Cleaning and user maintenance shall not be made by children without supervision.
For the service technician
à
GEZE does not accept any warranty for combinations with third-party products.
à
Only combine third-party products with original parts following agreement by GEZE. Furthermore, only origi-
nal GEZE parts may be used for repair and maintenance work.
à
The power connection and safety earth conductor test must be carried out in accordance DIN VDE 0100-610.
à
Use a customer-accessible 16-A overload cut-out that disconnects the system from the power supply as the
line-side disconnecting device.
