Viper Pro
Quick Reference Sheet
1.
Turn power on to the Viper.
2.
On the “CAN Initialization Results” screen press Start Viper (as long
as the nodes being used are found)
3.
Press Product Control – this will access the CAN Controller Status
screen.
4.
Select the 3
rd
box down from the top – this will access the Node 1
Settings screen. This is where you provide – Rate, Density, and Gate
Calibration.
5.
Press the box with the current value to change to your appropriate
setting – The three settings that must be set are as follows.
Rate Cal = Rate you want to apply.
Density = Density of the product you are applying.
Spreader = The gate calibration number.
6.
Press OK once the values are set.
7.
Press OK once more to access the main screen.
8.
Press MENU > SETUP > LOCAL > PROFILE > LOAD PROFILE.
Select the profile that you want and press OK. You will be prompted
to restart the Viper, press OK then press YES to exit the program,
then press EXIT TO MENU, then select VIPER PRO.
9.
Repeat step 2(You will not lose any product information)
10.
To start a job – Press MENU > START JOB > NEW JOB or
FROM FILE, if it is a new job the job will be auto named with
today’s date, if you wish to change the name press
←←
and input
your new job name. Then press NEXT.
11.
Product Selection Screen – Press NEXT.
12.
Product #1 Setup Screen – Enter your product name or choose
from previous names you have entered by pressing the
▼
. If you are
using Variable Rate Control then select VRC and browse your card
for the correct file. Select the rate from the rate field. then press
OK. This will return you to the main screen.
13.
Touch the RT RA section of the screen on the lower left of the Viper
to turn the Product Nodes on to the automatic function. Now the
chain and or spinners will respond to your toggle switch.
14.
To end your job press MENU > CLOSE JOB > YES.
15.
To exit the Viper and power down press MENU > EXIT > YES,
once at the Program Selection Screen press the blue power button on
lower left of the Viper.
Summary of Contents for Speedy Spread
