Gfp 663TH
April 2021
7
Disconnect from the power supply when the machine is not in use for a long time
.
When the machine lies idle for a long period of time, raise the top rubber roller to avoid flat
spots on the rubber surface.
Do not cover the surface of the machine until the machine has completely cooled.
Perform only the routine maintenance procedures referred to in these instructions.
6.
Operating Conditions
Place machine on level surface
Environment requirements
：
Ambient temperature: 50
⁰
F - 104
⁰
F
Humidity
：
30%—80%
；
ideal humidity
：
55%
Due to the static on film rolls, you should try to keep the environment clean.
Provide enough space around machine to ensure the safe and effective operation. The minimum
area covered is 8 ft. x 10 ft.
Do not directly cut the films on the surfaces of the rubber rollers to avoid damages to the rollers.
Do not put burrs, sharp knives or extra thick and hard materials in between the rollers. Do not
leave objects like tools, rulers, knives, etc. on the working panels or the side cabinets to avoid
their being rolled into the machine accidentally and damaging the rollers.
For repairs and replacements, please contact your local distributor. Unauthorized repairs and
dismantling will affect future maintenances of the machines.
The machine can laminate continuously objects less than ½” thick.
For objects over ½” but less than 1” thick, use the foot pedal switch.
Operator should be present while machine is in operation.
Warning: Do not keep the machines in direct sunshine or near it.
Do not keep the machine in dusty places or places with strong vibrations.
