Gfp 865DH-4
March 2021
22
4.
Return the film core adaptor to the supply shaft.
5.
Position the film in the middle of the supply shaft and measure the distance from one side of
the film core adaptor to the side frame or use the substrate width positions pre-printed on the
supply shaft.
6.
Fasten the screws for film core adaptor (Note: there should be 1/8” clearance between the
positioning and the adjusting sleeves of the film core adaptor to make brake adjustment easier),
7.
Adjust the brake tension by turning the adjusting sleeve (
Note:
the brake tension should not
prevent roll from turning)
8.
Repeat process with the bottom supply shaft.
9.
Position bottom roll same distance from side frame as the top supply roll or use the pre-printed
positions on the supply shafts.
Warning Ensure the
safety shield is in place before operating the
Laminator. Operating without the safety shield can cause serious injury
1. Axles of the supply shaft 5. Adjusting sleeve
2. Cold laminating film (lining paper) 6. Fastening screws for the film core adaptor
3. Film Core 7. Film core adaptor
4. Positioning sleeve
