Final assembly
11
1. To protect the tool shed from falling over, connect it with a building, etc., by fastening the
tool shed with a wire, etc. (not included in delivery) to the metal clasp.
Or attach the four anchoring brackets to the four corners and screw them onto the
foundation or use ground stakes (ground stakes and screwing material not included).
2. Align each corner of the tool shed at a right angle and make sure that all screws have
been properly tightened.
Metal clasp
Wire etc. not included in delivery
Remove the screws that
secure the side wall, attach the
anchoring brackets and screw
the screws back on tightly.
