HANNOVER NON-STORAGE BEDFRAME ASSEMBLY
INSTRUCTIONS
Batch No. PO759 / PO760
Page
2
of
12
IMPORTANT - READ CAREFULLY - RETAIN THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
INFORMATION
•
This product is intended for a maximum person’s weight of 130kg per side. Do not exceed this weight
•
Incorrect installation could lead to injury, take care following instructions.
•
Due to the size of this product we recommend that it is assembled in the room intended for use
•
When you are ready to start, make sure that you have the right tools, plenty of space and a clean, dry
area for assembly
•
Unwrap all packaging materials and place the components on top of the carton box or on a clean floor to
prevent it from scratching
•
Check the pack and make sure you have all the parts listed
•
Ensure that this product is fully assembled and secured as illustrated before use
•
Check all screws or bolts are tightened and inspect regularly.
•
This product should only be used on firm, level ground.
•
Dismantle for transportation.
•
Only use recommended accessories.
•
Tools are not included.
WARNINGS
•
DO make sure the legs remain in contact with the ground.
•
DO keep small parts out of reach of children.
•
DO NOT use power tools to construct this product.
•
DO NOT tighten screws or bolts until fully assembled.
•
DO NOT over tighten screws or bolts.
•
DO NOT use this product if parts are missing, damaged or worn.
•
DO NOT stand on the product.
CARE INFORMATION
•
Never use scourers, abrasives or chemical cleaners
•
To clean wipe with a sponge and warm soapy water. Do not use solvent based cleaners or detergents as
they can bleach or damage the product
