Display Cases / Plug-in
13
www.ggmgastro.com
9.8.In case of breakdowns:
If a failure occurs on display refrigerators make sure that the reason of the failure is not improper maintenance.
If a failure is occurred for any other reason than the possible reasons below please contact with our after sales
technical services.
Some reasons for a breakdown and fixing instructions are given below.
a)
If the cabinet is not working and stopping continuously;
Check if the electric is disconnected.
Check if the starting switch is on and the working lamp is illuminated.
Check if the electric cable is connected properly.
If there is no electricity for any other reason, call the nearest technical service.
If any breakdown occurs or if the electric power is cut and the work of the cabinet is interrupted
for a certain period of time, all the food products should be taken out and transferred to a cooling
room to keep the temperature of the food products fixed.
b)
If the fridge is not cooling appropriately;
Check if the display area of the cabinet is filled properly so that the air holes are not blocked
and there is no excessive load.
If the cabinet is not defrosted for more than 6 hours, the ice should be melt (defrost) and it
should be cleaned before starting operation again.
Check if the cabinet is away from air circulation (ventilators, windows or open doors) and
heaters.
Check with a spirit-level if the cabinet is appropriately leveled.
Under normal conditions if the above are fulfilled the cabinet should start working appropriately. After
the digital thermostat is set, 24 hours should be given for the desired temperature.
9.9.Safety instructions:
Follow the instructions below in a case of gas escape or fire:
If there is gas escape from the refrigerator, ventilate the room. If it cannot be ventilated leave
the room. The cooling gas is not poisonous but contains oxygen and may result in suffocate
symptoms.
In case of fire turn the cabinet off from its starting switch. Only use dry fire extinguishers to
take out the fire. Never use water.
9.10.Controls :
Connect electricity to start the refrigerator and turn the starting switch on. The working lamp will turn on
when it starts to work. To illuminate the display area, turn on the illumination switch (inside the lamp
area). Check if the set value is appropriate for food products. For appropriate cooling the set value can be
changed. When ice in the refrigerator is melting the defrost lamp turns on.
9.11.Maintenance :
See if the electricity is disconnected from the display refrigerator and it is turned off before any
maintenance or cleaning process. Appropriate gloves have to be used during maintenance or cleaning.
a)
All internal or external parts should be cleaned with a warm water and neutral soap weekly. Dry
the area carefully with a soft cloth; never use flammable, poisonous or corrosive cleaning
products. Never use water jets to clean the cabinet. Drainages are installed in the cabinet to drain
the water from melting and cleaning and a cup for liquid is used to collect the excess water and
