GHL Doser Resource Guide
Release 07/2018
32
6.
Click “OK” and save your settings.
Need a visual?
See how to setup a 1-sensor or 2-sensor ATO function by clicking the link
below.
1-Sensor ATO Setup:
2-Sensor ATO Setup:
How to Program Magnetic Stirrers
Each GHL Doser supports 4 magnetic stirrers per station, allowing up to 16 total stirrers and 16
dosing pumps.
Here is how to program a Magnetic Stirrer:
1.
Click on “Extras” drop-down box and select “Magnetic Stirrers”.
2.
Select the Magnetic Stirrer number and input the following information:
●
Activated by – Select to what device will cause the magnetic stirrer to activate.
●
Index – Select the dosing pump number which will be assigned to this stirrer.
●
Lead time – Select how many seconds in-advance the stirrer will turn on before the
dosing pump runs.
●
Daily stir cycles – Select how many times this stirrer will turn on throughout the day.
Aside from the designated lead time.
●
Stir duration – Select how many seconds the stirrer will run when activated.
●
Speed – Select the speed at which the stirrer should run. Max speed is 14.
3.
Save your settings.
