E40.0.2x.6C-01
Operating Manual EASY
LOG
80NS
page 8 of 16
6. Operation
6.1 Operating possibilities at the device - display selection
Function
Procedure
Display max-value
Push button
shortly
The max-value is displayed for 4 seconds.
(The max-value display function is signalled by the display el-
ement “MAX”).
Note:
You can immediately deactivate the max-value dis-
play by pushing the button again.
Delete max-value
Push button
for about 5 seconds.
“CLr” is displayed and the max-values of all measuring
channels are deleted.
Display min-value
Push button
shortly
The min-value is displayed for 4 seconds.
(The min-value display function is signalled by the display el-
ement “MIN“).
Note:
You can immediately deactivate the max-value dis-
play by pushing the button again.
Delete min-value
Push button
for about 5 seconds.
“CLr” is displayed and the min-values of all measuring
channels are deleted.
6.2 Operating possibilities at the device - logger operation
Function
Procedure
Display and adjust
cycle time
Push button
and
at the same time.
The main display shows “CYCL”. The secondary display
shows the currently adjusted cycle time [in sec.].
If the logger is currently not recording, the desired cycle time
[2 sec to 5h (18000 sec)] can be adjusted via the buttons
and
.
Press button
again to confirm your adjustments and to
leave the menu.
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving.
Start recording
Push button
for about 5 seconds.
The main display shows “run”.
The secondary display shows “no”.
To start recording select “YES” with the arrow keys
(button
or
) and verify with
.
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving.
2
2
3
3
SET
1
2
2
3
SET
1
SET
1
2
3
SET
1
