E40.0.2x.6C-01
Operating Manual EASY
LOG
80NS
page 12 of 16
9. Specifications
Input signal,
measuring range
Note: Input is not isolated from EASYBus
EASY
LOG
80NS-..-E420
4.00 … 20.00 mA
EASY
LOG
80NS-..-E020
0.00 … 20.00 mA
EASY
LOG
80NS-..-EV010
0.00 … 10.00 Volt
EASY
LOG
80NS-..-EV01
0.00 … 1.00 Volt
EASY
LOG
80NS-..-EV02
0.00 … 2.00 Volt
Input resistance
0(4) .. 20 mA Rs = ~ 50 Ohm
0 .. X Volt Ri > 300 kOhm
Display range
-
1999 … 9999 Digit, programmable
(Recommended display range: < 2000 digit)
Decimal point
any position.
Display unit
programmable, a selection of more than 25 units is given in
the software used
Resolution
1 digit
Accuracy
±0.5 % FS (at nominal temperature)
Display
two 4½-digit LCD-displays (about 7 and 5.8 mm high)
Interface
EASYBus
Busload
equals to 2 EASYBus-elements
Battery
1x fixed lithium cell (Li / SOCl2) 3.6V / 1200 mAh (= 4.32
Wh)
Battery life time
depending on the chosen measuring cycle about 5 years
(at 15 minutes and nominal temperature).
Measured value memory
250.000 measuring values
Measuring cycle
2 seconds to 5 hours (18000 seconds)
Memory type:
›cyclic logger‹
• recording can be activated by start/stop function (i.e. key-
press, boundaries).
• 64 independent recording sets are possible.
›ring logger‹
The logger records continuously;
as soon as the whole memory is used the old data of the
beginning are overwritten.
Recording period
depending on the chosen measuring cycle
i. e. 521 days at 3 min measuring cycle
7.1 years at 15 min measuring cycle
Alarm function
alarm points selectable within the measuring range and
alarm delay adjustable from 0 to 500 min
