11
The device initialises after the supply voltage is connected. The device type and
software version appear in the display. After the device is finished initialising, it
enters the operating level and the current temperature and all safety-related
settings are displayed. The peak value buffer is displayed by briefly pressing the
button.
The configuration level is displayed by pressing and holding the
button for 2
seconds. All parameters determining the properties of the device are programmed
here. A password must be entered in order to enter the safety area of the
configuration level. If an incorrect password is entered, an error message appears
in the display. The device switches back to the operating level after this message or
if no password is entered. After an incorrect password has been entered three
times, the device enters a safety timeout for 60 minutes. The progress of this safety
timeout is shown in the display. The safety area is accessible with entry of the
correct password. Settings can be made here, which must be protected from
unauthorised change. After the last menu item or if no button is pressed for more
than 2 minutes, the devices switches back to operating level automatically and the
current measurement is shown in the display. The configuration level can be exited
at any times by pressing the
button for 2 seconds.
Error messages
If errors occur, the messages are shown in clear text on the display. This
simplifies troubleshooting.
Note for commissioning!
The device has standard preconfigured factory settings. Therefore, it
must be adapted to the specific application.
Service
Service of the device is only possible in the factory. Please refer to
chapter 6 Return to manufacturer on page 25.
