HD2303
- 5 -
V1.6
HD2303.0
1.
Input for probes, 8-pole DIN45326 connector.
2.
Battery symbol: displays the battery charge level.
3.
Function indicators.
4.
Secondary display line.
5.
DATA/ENTER
key: during normal operation displays the maximum (MAX), the minimum
(MIN) and the average (AVG) of current measurements; in the menu, confirms the current
selection.
6.
CLR/ESC
key: resets the maximum, the minimum and the average of the captured
measurements; in the menu, it resets the value set with the arrows.
7.
HOLD/
key: freezes the measurement during normal operation; in the menu, increases the
current value.
8.
UNIT/MENU
key: it allows selection of the unit of measurement; when pressed together with
the DATA key, it allows to open the menu.
9.
STD-BY
: during normal operation, it sets the hot-wire probe to stand-by; in the menu, changes
the section's unit of measurement to m
2
or inch
2
.
10.
REL/
key: during normal operation enables the relative measurement (displays the difference
between the current value and the logged value when the key is pressed); in the menu, decreases
the current value.
11.
ON-OFF/AUTO-OFF
key: turns the instrument on and off; when pressed together with the
HOLD key, disables the
AutoPowerOff
function.
12.
MAX
(maximum value),
MIN
(minimum value) and
AVG
(average value) symbols.
13.
Main display line.
14.
Line for symbols and comments.
Summary of Contents for Delta OHM HD2303.0
Page 4: ...HD2303 4 V1 6 Anemometer HD2303 0 ...
Page 15: ...HD2303 15 V1 6 AP471S4 ...
Page 31: ......
