E40.0.6x.6C-01
Operating Manual EASY
LOG
80BIN
page 5 of 14
3. Product description
3.1 Required accessory
The
EASY
LOG
80BIN
is configurated, started and read-out via the
EASYBus
-interface.
Therefore the following accessories are required:
Level converter
- RS232 <>
EASYBus
(i.e. EBW 1, EBW 64, EBW 240)
- USB <>
EASYBus
(i.e. EBW 3)
Connecting cable: level converter to
EASY
LOG
GSOFT 40K
(version >7.14):
Windows software to start the logger and read out the logger-data
EASYBus-Configurator
(version >2.0):
for the configuration of the extended settings
3.2 Notes on the logger’s delivery status
The delivered logger is in a “sleep mode”, that means nothing is displayed and the
power consumption is at its minimum. When there is a communication with the software
for the first time, the EASY
LOG
leaves the sleep mode and ›Stop‹ is displayed. Then the
device is ready for operation.
Note:
That sleep mode (nothing is displayed) cannot be restored again.
“Stop“ or “Halt“ are similar to the sleep mode. Both of that operation
modes ensure minimum consumption.
Note:
Logger start over keypad:
before logger start over keypad, logger time must be adjust with
GSOFT 40K.
3.3 EASYBus connector
Assignment of panel jack
(view on pins)
EASYBus
connection
not connected
