E40.0.6x.6C-01
Operating Manual EASY
LOG
80BIN
page 7 of 14
Delete min-value
Push button
for about 5 seconds.
“CLr” is displayed and the min-values of all measuring
channels are deleted.
5.2 Operating possibilities at the device - logger operation
Function
Procedure
Display and adjust
cycle time
Push button
and
at the same time.
The main display shows “CYCL”. The secondary display
shows the currently adjusted cycle time [in sec.].
If the logger is currently not recording, the desired cycle time
[2 sec to 5h (18000 sec)] can be adjusted via the buttons
and
.
Press button
again to confirm your adjustments and to
leave the menu.
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving.
Start recording
Push button
for about 5 seconds.
The main display shows “run”.
The secondary display shows “no”.
To start recording select “YES” with the arrow keys
(button
or
) and verify with
.
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving.
Stop recording
Push button
for about 5 seconds.
The main display shows “HoLd”.
The secondary display shows “no”.
To stop recording select “YES” with the arrow key
(button
or
) and verify with
.
Note:
If no key is pressed for more than 2 min, the menu is
quit without saving.
Notice:
If you have activated one of the following options
• “logger stop via buttons disabled”
• “do not stop active logger”
at the configuration of the logger the menu to
stop the recording cannot be called.
3
SET
1
2
2
3
SET
1
SET
1
2
3
SET
1
SET
1
2
3
SET
1
