E40.0.6x.6C-01
Operating Manual EASY
LOG
80BIN
page 9 of 14
7. Operating displays
The
EASY
LOG
provides two LCD-displays:
7 mm (main display) and
5.8 mm (secondary display).
7.1 Measured value display
The LCD mainly displays the measured values:
a)
AL
Logg
MEASURED
VALUE
DISPLAY
a)
main display:
measured value
sec. display:
empty
• The arrow “Logg“ indicates that the logger is recording.
• The arrow "AL" indicates that an alarm is present.
7.2 Logger status messages
At stand-alone-operation (= no EASYBus connected) logger status messages are dis-
played.
STOP
:
The
EASY
LOG
recording has been
›stopped‹.
The logger memory is empty.
Note:
At this state the power consumption is at its
minimum.
HOLD
:
The
EASY
LOG
recording has been
›halted‹. No data is stored,
but the logger memory contains data.
The number of the saved recording sets is shown at the
secondary display.
START DELAY
:
The logger is activated, but no data is recorded yet.
As soon as the start delay is run out the logger begins with the
recording according to the programmed starting condition.
START ALARM
:
The logger is activated, but no data is recorded yet.
The logger begins with the recording as soon as the measured
values are within the selected min- and max-alarm boundaries.
