EN
Original operating instructions 11/2014
GHOST EPAC
E-HYBRIDE ANDASOL & ANDASOL X
E-HYBRIDE TERU & TERU FS
114
1. Unscrew the dust cap from the valve.
NOTE:
Your EPAC is equipped with a Sclaverand valve.
2. Loosen the small retaining nut at the top of the valve
3. Check the air pressure with a suitable tyre pressure gauge or an air pump
with pressure gauge.
NOTE:
If necessary, please ask your specialist bicycle dealer to show you
how to use the pressure gauge.
If the air pressure is too low:
increase the air pressure.
If the air pressure is too high:
reduce the air pressure by letting air out through the valve.
Check the air pressure again.
4. Retighten the small retaining nut at the top of the valve.
5. Screw the dust cap back on to the valve.
NOTE:
A bike pump with pressure gauge allows you to check the inflation pressure
while inflating. First allow a little air to escape from the tyre,
then inflate to the required value.
6.1.2.4 Checking that the tyre is correctly fitted
1. Lift the front wheel.
2. Turn the front wheel by hand.
The tyre must run smoothly.
There must be no wobble or eccentricity.
3. Check the back wheel in the same way as the front wheel.
