61
E-HYBRIDE TRAIL 9000 LADY / MAN
E-HYBRIDE TRAIL 4000 LADY / MAN
E-HYBRIDE STREET LADY / MAN
Installing the front wheel
1.
Remove the transport lock from the brake pistons
2.
Pick up the EPAC by the handlebars.
3.
Position the hub of the front wheel under the fork ends of the front-wheel fork.
4.
Insert the wheel so that the brake disc slides smoothly between the brake pads.
5.
Lower the fork carefully until the axle is flush with the stop of the fork ends on the left and
right.
·
In the case of clamping with a quick-release axle (E-Hybrid Street and Trail 4000):
Close the quick-release axle in accordance with
section 8.4.1, Opening and closing
the quick-release axle on the front wheel.
·
In the case of the thru axle (E-Hybrid Trail 9000):
Push the thru axle from the left through the fork dropout and the hub.
Clamp the front wheel hub.
See
section 8.4.2, Opening and closing the thru axle
.
6.
If your EPAC has been retrofitted with a hub dynamo:
Connect the plug-in connection between the hub dynamo and cables.
7.
Operate the front wheel brake several times with the EPAC stationary after you have
reinstalled the front wheel.
8.
Lift up the EPAC by the handlebars and turn the front wheel by hand. If a brake block
is in contact with the wheel rim, this can indicate incorrect mounting of the hub in the
fork dropouts. In this case you should open the quick-release lever and shake the front
wheel lightly to and fro (at right angles to the direction of travel). Repeat the installation