Fueling instructions for use with ASTM E3053-17
start-up phase you may need to reposition the fuel for maximum combustion.
This usually will happen around 30-35 minutes. If the flames on top start to go
out, open the door and grab the raw fuel on the bottom and move it on top in a
pile to get any raw fuel burnt up.
Set the fan control to the high position at five minutes.
The test load should be loaded at the bottom end of the allowable coal bed within
0.2lbs.
When loading, use the smaller of the test pieces to gently level the remaining
fuel. Use the by-pass if needed. Three of the smaller pieces cut at 15’’ are to be
placed in a north/south direction on the bottom with gaps between the pieces.
The remaining two pieces are on top in an east/west direction with gaps between
fuel. See test fuel picture below for an example. The door should be open around
one and a half to two and a half minutes. Once the fuel is loaded leave the door
wide open and let the flames build before closing the door. Once the door is
closed there should be flames on top of the fuel right away.
High Burn Test Fuel:
End the test at the low end of the allowable remaining weight.
22 of 142
Summary of Contents for GWS-2200
