Fueling instructions for use with ASTM E3053-17
four minutes. Use the by-pass at the start of the test if needed. There should be
minimal gaps between all fuel pieces. Three smaller pieces in a North/South
direction and the remaining three pieces on top in an East/West direction (see
test fuel picture above). Keep the primary control open until six to seven minutes
then shut the control half way between the high and low setting until 15% of the
fuel load has been consumed or if you see the combustion getting noticeably
dirtier, set the control at the desired setting.
The setting for the low is closed to the stop.
The setting for the medium burn is 0.030’’ open from the low setting.
Moving Fuel Load:
It may be necessary to move the fuel load at some point during the medium and
low burns. Keep an eye on weight drop and stack draft to determine when to
move the fuel if needed.
24 of 142
Summary of Contents for GWS-2200
