51
•
Out of range
: condition set according to the range acquired by the data
•
M-bus status notify
: condition set according to the creation of a new event. Always refer to the
meter’s documentation to activate this condition.
The next paragraphs will show in detail the parameters to configure the above.
Figure 41 - Selecting an event
12.1.3
Condition set according to the maximum value acquired
Select
Max Value
.
Figure 42 - Completing the creation of an event
The cells to be filled out are:
•
Event Name
: enter the name of the event being created
•
Data Type
: select the type of meter data. The data you can select are those that have already been
set for every single meter. For more information, refer to Chapter 11.1.12
•
Alarm threshold (Max)
: select an alarm threshold. The value can be both positive or negative
•
Dead band
: enter the value for which the condition does not occur. This feature allows the system
to react with a certain delay to the actions to be taken based on the values measured beforehand
Figure 43 – Dead band
