53
•
Output 1
: when an event occurs, you can enable an operation according to the device connected to
Output 1
, such as:
o
Open
: commands to open
o
Close
: commands to close
o
Pulse
: generates a pulse
•
Output 2
: when an event occurs, you can enable an operation according to the device connected to
Output 2
, such as:
o
Open
: commands to open
o
Close
: commands to close
o
Pulse
: generates a pulse
•
Add to Log
: stores the alarm in the meter’s log
•
Send Email
: sends an email notification in the event of an alarm (Ref. Chapter 5.1.4, 8.1.4.)
•
Save
: Press
Save
to save the configuration
12.1.5
Condition set according to the value out of range
Select the
Out of range
item.
Figure 46 - Completing the creation of an event
The cells to be filled out are:
•
Event Name
: enter the name of the event being created
•
Data Type
: select the type of meter data. The data you can select are those that have already been
set for every single meter. For more information, refer to Chapter 11.1.12
•
Lower threshold
: select the lower alarm threshold. The value can be both positive or negative
•
Upper threshold
: select the upper alarm threshold. The value can be both positive or negative
•
Dead band
: enter the value for which the condition does not occur. This feature allows the system
to react with a certain delay to the actions to be taken based on the values measured beforehand
Figure 47 – Dead band