2.
Note:
After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.
To Enter a User Code
：
Enter the Programming mode
1. Enter the slot position code
「＊
01~
＊
10
」
→
????
（
user code 4 digit
）
→
（
beep
）
→
enrolled
→
Press # to exit from the programming mode, or program other operating.
2.
Note:
The codes"0000","1234" or master code are not be used for PIN code.
To Program Relocking Timer
（
relay
）：
Enter the Programming mode
1. Press
「＊
20
」
Followed by the number of seconds the relay should open
→
「
05
」
=5
seconds
（
01 ~99 = seconds
）
→
（
beep
）
→
enrolled
→
Press
「
#
」
to exit from the
programming mode, or program other operating.
2. Enter
「
00
」
Sets the relay to latching mode.
(Correct code entered opens the relay,
and the relay stays open until the correct code is entered again).
To Delete a User Code
：
Enter the Programming mode
→
Press the slot position code of your choice to delete
(example "06")
→
Press
「＊
06
」
→
「
0000
」
→
（
beep
）
→
delete
→
Press
「
#
」
to exit
from the programming mode, or programming other operating.
To Change the Master codes:
Enter the Programming mode, Enter
「＊
00
」
Followed by the new 4 digit master code
→
（
beep
）
→
enrolled
→
Enter
「
#
」
to exit from the programming mode, or program other
operating.
4. Wiring
diagram:
+
REED
REED
B
P
NC
NC
Com
Co
m
NO
NO
1
2
3
12Vdc
Power
Supply
Power Supply
Push Button
Buzzer
Tamper
Switch
Tamper switch
contact output
(free voltage contact)
Master Code
resetting(2-3)
to Factory
Code"1234"
FAIL-SAFE
LOCKING DEVICE
Contact door reed switch
Diode
This reed switch is used
to reset the re-locking time
to 0 second when the door is moved.
(Using N.O. contact in case of door closed,
changeover to N.C. When door is moved)
(Fail-safe locks)
(Fail-secure locks)
Copyright Gianni Industries, Inc. All Rights Reserved.
PMUDG5 Ver. B Publish:2009.06.15 Page: 2/ 3
