10
REPLACING FUSE AND THE INTERIOR LIGHT
Follow the below steps for replacing the
plug fuse (12/24V):
• Unplug the DC power plug.
• Turn the cap anticlockwise to remove.
• Replace the defective fuse with a new one
that has the same rating 32V 10-15A.
• Tighten the cap.
WARNING: The rated current for the fuse
should be within 10-15A, no less than 10A
and Max is 15A. A fuse with rated current
less than 10A will be easily burnt during compressor starting
procedure; a fuse with rated current more than 15A will burn
the battery fuse in the car when the fridge/freezer uses the car
battery.
Follow the below steps for replacing the Display Panel:
• Unplug the power plug and open the fridge/freezer’s lid.
• Pry out the transparent cover with a screwdriver.
• Unscrew the Display Panel mounting board.
• Pull out the connector wire terminal from the Display Panel.
• Replace the defective Display Panel with a new one.
• Fit new Display Panel using reverse of removal instructions.
• Press the transparent cover back into the housing.
CLEANING AND MAINTENANCE
Always disconnect the device from the mains before you clean
and service it.
• Occasionally clean the device interior and exterior with a
damp cloth. Do not use abrasive cleaning agents or hard
objects during cleaning as these can damage the fridge/
freezer.
• Clean the heat dissipation vents frequently to ensure good
heat dissipation.
• Do not leave the fridge/freezer off with food inside or the lid
closed.
FUSE
Cap
