3
unit assembly & set-up (cont.)
TRAILER WIRING SCHEME (CHW UNITS ONLY)
Trailer Wiring Scheme
(View from beneath unit)
Ground Strap -
fastens to bottom
of taillamp mounting
bracket with #10 x .50
self-drilling screw
Taillamp Plug -
Plugs into Taillamp
Large Harness Clips (5) -
Fastens harness to unit
Small Harness Clips (2) -
Fastens harness to unit
Large Harness Clips (2) -
Fastens harness to unit
Install Plug for connection with Vehicle (Plug Not Included)
Trailer Plug
Wiring Code:
Red - Right signal
Yellow - Left signal
Brown - Taillights
Green - Ground
DISCHARGE ASSEMBLY (ALL UNITS)
Safety Note: Assistance is required when installing discharge stack and elbow. If
access to lifting equipment is possible, it is highly recommended.
Important Safety Note: To prevent unit rollover during Discharge Assembly,
lock rear support leg in lowermost position possible. Failure to do this may
result in injury or death and/or damage to unit or property.
•
Place discharge stack atop power unit, with
boom pivot brackets facing out toward right rear
of unit (from driver’s perspective). Insert eight
3/8-16 x 1-1/4” hex bolts (3:2), each fitted with
one flat washer (3:3), through bolt flange holes,
securing with flat washers, lock washers and
nuts (3:3-5). Tighten securely.
•
Attach discharge elbow (3:1) to top of stack,
with discharge directed toward towing hitch,
using same hardware as in above step.
Tighten securely.
Boom pivot
brackets on
stack should
face toward right
rear
of unit
Not
for
Reproduction
