GVTP GM32-R0103.1
3
unit assembly (cont.)
BLADE ENGAGEMENT LEVER ASSEMBLY
(125KAW & 13BS only)
•
Remove bridge pin and washer (4b:14-15)
holding adjustment rod to engagement lever
(4b:1) and remove upper adjustment rod
assembly (4b:13,16-20).
•
Remove 3/8” bolt and lock nut (4b:4-5) from
engagement lever bracket (4b:3 – attached to
engine deck). Slip bottom of lever down
through slot in engagement lever bracket,
making sure bend is toward left side of mower
to give clearance for fuel tank assembly. Re-
install bolt and lock nut through top hole in
lever. (CAUTION: Do not over tighten lock
nut).
•
Remove jam nut and lock washer (4b:19-20)
from ball joint (4b:18); install ball-joint stud
through hole in blade belt cam (4b:21) with nut
and lock washer toward right side of mower.
Adjust rod length to ensure cam locks when
lever is fully engaged and attach to lower end of
handle with washer and bridge pin previously
removed.
bolt goes thru
this hole