4
Model ....................................................... Gear Ratio ..................................Input Speed
GP8100-2.6 ................................................... 2.6:1 .........................................
1500 RPM
GP8100-3.1 ................................................... 3.1:1 .........................................
1800 RPM
GP8100-3.8 ................................................... 3.8:1 .........................................
2200 RPM
GP8100-4.5 ................................................... 4.5:1 .........................................
2600 RPM
HORSEPOWER RATINGS:
The rating shown are the power requirements for the pump
. Gas engine
power outputs must be approximately twice the pump power requirements shown above.
We recommend a 1.15 service factor be specified when selecting an electric motor as the power source.
To compute specific pump horsepower requirements, use the following formula:
GPM X PSI
1450
Specifications
Consult the factory for special requirements that must be met if the pump is to
operate beyond one or more of the limits specified above.
= HP
Maximum
Flow
Maximum
Pressure
Maximum
Speed
Power
Required
Plunger
Diameter
NPSHR
Model
GPM
PSI
RPM
HP
in
foot of head
GP8155
75.5
3000
580
145
2.17
23
GP8160
90
2500
580
147
2.36
23.6
GP8165
105.6/120*
2000
580/658
142/166
2.55
26.2
Max. Flow
Maximum
Pressure
Maximum
Speed
Power
Required
Plunger
Diameter
NPSHR
Model
L/min
Bar
RPM
kW
mm
mWs
GP8155
285
200
580
108
55
7.0
GP8160
337
170
580
110
60
7.2
GP8165
400/455*
140
580/658
106/123
65
8.0
U.S. Measurements
Metric Measurements
U.S. (Metric)
Maxiumum Inlet Pressure
................................ Up to 29 PSI* .......................(2.0 bar)*
Plunger Stroke
................................................. 2.83” .....................................
72mm
Maximum Temperature of Pumped Fluids .......
Up to 86
o
F*..........................
(30
o
C)*
Pinion Shaft Diameter
...................................... 1.77” .....................................45 mm
Key Width
......................................................................................................14 mm x 9 mm x 70 mm
Crankshaft Mounting
.....................................................................................
Either side
Shaft Rotation
................................................................................................
See Page 2
Inlet Ports
......................................................................................................
(2) 3” BSP
Discharge Ports
.............................................................................................(2) 1-1/4” BSP
Crankcase Oil Capacity
................................... 4.2 Gal. ...............................(16.0 liters)
Weight
............................................................. 794 lbs. ................................
(360 kg)
Fluid End Material (GP8155/GP8160/GP8165) .............................................
Nickle plated Spheroidal Cast Iron
Fluid End Material (-1000 versions) ...............................................................
Bronze
*The specifications above are based on maximum pressure and RPM for intermittent duty using cold water.
