Assembly and maintenance
instructions
according to regulation DIN 82079
Version 06.20
Date: 21.10.2021
Name: Manual_ME-RV_EN
GIEBEL FilTec GmbH |
| Accessories & Spare parts:
7/9
Oil on the drying agent
If too many oil particles enter the adsorber, the oil particles close the pores of the desiccant and thus
prevent adsorption.
Ambient temperature too high
If the ambient temperature exceeds 80°C, the binding forces in the desiccant decrease. This means that
the incoming ambient air is only dried to a limited extent.
2. Positive or negative pressure builds up in the system
Valves are jammed / blocked
If the functionality of the valves is impaired by impurities, the pressure in the system increases.
Air flow rate too high
Too high an air flow rate can cause over- or underpressure in the system.
Contaminated filter element
The filter unit can be clogged by dirt particles and can therefore build up pressure in the system.
Oil on the drying agent
If oil particles get into the adsorber, the spaces in the fill can be filled with oil and the fill will stick
together. This can cause pressure to build up in the system.
3. Adsorber is damaged
Material resistance
When selecting the adsorber, the ambient and operating conditions should be considered. An aggressive
environment or liquid in the container can damage the adsorber.
Temperature range
The ambient and operating temperatures should not exceed or fall below the specified range, otherwise
the adsorber may be damaged.
Improper handling
Incorrect or improper handling can damage the adsorber. The recommended installation must be
observed.
Strong vibrations
Strong vibrations of the plant can damage the adsorber.
