Subject to alterations, 03.06.20
15/32
Start-up and calibration
Switch on the burner
Continuous heat requirement is necessary for further start-up!
LMV programmed
Start load preset
Use the values from the setting tables to preset the values.
Action button
Display
Description
When the firing machine is programmed,
run
is
displayed.
i/reset
skips the next steps an continues at the
section Start heat settings with curve point
P1
Small load.
Action button
Display
Description
Set the start position air flap.
Hold down
button A
and set the value with the
-
or + button
.
Move to the next curve point.
/reset
/reset
