RoadLED 50m
Page 4 / 20
Created
23.04.2021
rasa
Modified
06.10.2021
rasa
Object-ID
2214657
2 Introduction
To ensure proper installation, the following steps and notes must be complied with under all circum- stances.
Only this way can it be ensured that the product will work to complete satisfaction.
Hint
Read all instructions before starting installation. Our sales department will be happy to answer any questions
you may have.
2.1 Installation conditions product RoadLED
The RoaLED has been designed for outdoor application. Occasional immersion in shallow water (e.g. puddles)
for a period of max. 8 hours is no problem for the light modules.
The luminaire modules can be driven over with a maximum wheel load of 3.5 t without damaging the housing.
2.2 Storage
No additional measures are required for storage. Ensure that the modules are protected from damage when
packing them.
Ensure that the RoadLED is switched off and the battery is sufficiently charged (min. 50 – max. 80% of the
overall capacity) during storage, in order to protect the battery from discharge. If the RoadLED is stored for a
lengthy period, the charging condition must be checked at regular intervals. The self-discharge of 1% per
month is extremely low, but highly dependent on temperature. Lithium-ion batteries should be recharged
every 3 to 4 months to prevent deep discharge. The battery should always be recharged to min. 60% of the
overall capacity after every use!
The storage temperature must be between -10°C to +25°C, in order to ensure a long battery lifetime.
2.3 Disposal of the device
This product must not be thrown in the garbage.
In accordance with official local and national regulations, this product is to be recycled
appropriately.
European directive 2012/19/EU; waste electrical and electronic equipment (WEEE).
