4.
If GS2000 can’t read any tag (Blue LED [1 blink] -> 3 short beeps -> Red
LED [1 blink] -> Red LED [3 blinks every 2 seconds] when you press and
hold the SCAN button for 10 seconds)
It indicates that flash memory failure of GS2000 occurs. Send the handset
to GIGA-TMS for further inspection.
5.
If GS2000 can’t read any tag; besides, if you press and hold the SCAN
button for around 15 seconds, Blue LED lights around 10 seconds and
then goes off
Make sure you use 125KHz tag.
The antenna of the handset may be damaged or broken. Contact
GIGA-TMS to purchase a new reading head (PART NO: ACA2000-00) and
replace the old one.
6.
If GS2000 can’t read any tag; besides, if you press and hold the SCAN
button for around 1 second, Blue LED blinks once and then Red LED
blinks twice with two rapid beeps
It indicates that the battery power is very low. Change the new battery.
7.
If Blue LED lights for 10 seconds and then Blue LED blinks once every 2
seconds when you press and hold the SCAN button for 20 seconds
It indicates that the flash memory of GS2000 is almost full. Download the
data and then clean the data of the handset as soon as possible.
8.
If Blue LED lights for 10 seconds and then Red LED blinks once every 2
seconds when you press and hold the SCAN button for 20 seconds
It indicates that the battery power is low. Change the new battery.
9.
If GS2000 can’t be powered on
Change the new battery.
10.
If you have more than one GS2000 handsets, for example, 10 handsets,
how many base (the cradle) do you need
These 10 handsets share one base.
