Appendix
- 82 -
Rebuilding an Array:
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies
only to fault-tolerant arrays such as RAID 1, RAID 5, or RAID 10. To replace the old drive, make sure to use a
new drive of equal or greater capacity. The procedures below assume a new drive is added to replace a failed
drive to rebuild a RAID 1 array.
While in the operating system, make sure the chipset drivers have been installed from the motherboard driver
disk. Then launch the
AMD RAIDXpert
from
All Programs
in the
Start Menu
.
Step 1:
Enter the login ID and password (default: "admin"),
and then click
Sign in
to launch
AMD RAIDXpert
.
Step 2:
Select the RAID array to be rebuilt under
Logical
Drive View
and click the
Rebuild
tab in the
Logi-
cal Drive Information
pane.
Step 3:
Select one available drive and click
Start Now
to
start the rebuilding process.
Step 4:
The rebuilding progress is displayed on the
screen and you can select
Pause
/
Resume
/
Abort
during the rebuilding process.
Step 5:
When done, the array's status on the
Information
page
in the
Logical Drive Information
pane will display as
Functional
.
Summary of Contents for GA-870-UD3P
