Appendix
- 100 -
Figure 2
B. Installing Windows XP
Before installing Windows XP, connect a USB floppy disk drive to your computer first because you need to in
-
stall the SATA RAID/AHCI driver from a floppy disk that contains the driver during the OS installation. Without
the driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver
from the motherboard driver disk to a floppy disk. Refer to the methods below.
Method A:
•
For the Intel Z68, copy all files in the
\BootDrv\iRST\32Bit
folder to your floppy disk. To install Windows
64-Bit, copy the files in the
64Bit
folder.
•
For the Marvell 88SE9172,
copy all files in the
\BootDrv\Marvell\RAID\Floppy32
folder to your floppy
disk. To install Windows 64-Bit, copy the files in the
Floppy64
folder.
For AHCI mode, depending on whether you want to install the 32- or 64-bit version,
copy the files in the
AHCI\Floppy32
or
AHCI\Floppy64
folder.
Method B:
Steps:
1: Use an alternative system and insert the motherboard driver disk.
2: From your optical drive folder, double click the
Menu.exe
file in the
BootDrv
folder. A Command Prompt
window will open similar to that in Figure 2.
3: nsert the blank formatted disk (if you're using a USB floppy disk drive, make sure it is designated as drive
A). Select the controller driver by pressing the corresponding letter from the menu and press <Enter>. For
example, from the menu in Figure 2,
•
For the Intel Z68, select
8) Intel Rapid Storage driver for 32bit system
for Windows XP 32-bit op-
erating system.
•
For the Marvell 88SE9172, select
7) Marvell RAID driver
. (For AHCI drive(s), select
Marvell AHCI
driver
.)
Your system will then automatically copy the driver files to the floppy disk. Press any key to exit when finished.
