(2) Basic casing power switch control cable kit
Follow the connectors list below for installation (see figure below)
4-5 Connection of Fan Power Cable
This chassis has 1 x 12cm silent cooling fan at the front and 2 x 12 cm silent blue LED fans at the
rear. There are internal connectors that connect the front and rear fans making it into a single
3-pin power connector.
Required Tools: None
4-5.1 Insert the 3-pin connector into the system fan power connector on
the motherboard.
4-6 Installation of 5.25” Front Device Bay
4-6-1 Open the front panel door and side panel, remove the plastic bezel and EMI plate through
the inside of the chassis.
4-6-2 Slide-in the 5.25” device through the front panel to align it with the front panel bezels.
4-6-3 Secure the 5.25” device with the internal latch. Refer to the figure for installation procedure.
4-6-4 Installation complete.
Connector
Color
Power LED
Green(+) / Wite(-)
Power SW
) / White(-)
Different Motherboards have different installation areas, specifications, screw
holes and connectors. Please read the motherboard user manual supplied by the
motherboard manufacturer.
4-7 Installation of 3.5” Front Device Bay
The Installation of the 3.5” front device is the same as the installation of the 5.25” front devices.
Please refer to step 4-6.
Required parts: none
4-8 Installation of 3.5” Internal Device Bay
This chassis provides a removable/dual directional HDD rack to accommodate up to 5 hard disc
drives.
Required Tools: Thumbscrews (4 per hard disc drive)
4-8.1
4-8.2
Slide the HDD into the rack and secure the
HDD with the thumbscrews.
4-6.1
4-6.2
4-6.3
4-6.4
LOCK
10
English