PCMCIA Fast Ethernet card user’s manual
44
how to manually make driver and file modifications to enable your
card.
Enablers
You can use CARDGO.EXE to enable the Ethernet Card.
The CARDGO program
The program CARDGO.EXE communicates with the PC Card
controller of your computer. This program is needed only for DOS
environment network operating systems. You may install the Sock-
et and Card Services to your notebook before executing the driver.
If you do not have the Socket and Card Services program, please
contact your notebook vendor.
The Install program will automatically add a line to your
CONFIG.SYS file using the following syntax and format:
DEVICE=[path_name]CARDGO.EXE [/
IRQ
=xx] [/
IO
=xxx][/MEM=xxxx][/?]
where
[/IRQ=xx]
Specifies the hardware interrupt of your card. Default
value is
5
.
Valid IRQs are 3, 4, 5, ,9, 10, and 11.
[/IO=xxx]
Specifies the I/O address. Default value is
300
.
Valid port addresses are 300, 320, 340, 360, 240, and
280.
[/MEM=xxxx]
Specifies the memory address. Default value is
D400H
.
Valid memory addresses are D000H, D400H, D800H,
and DC00H.
[/?]
Displays all possible command syntax.
Summary of Contents for EE101-AEX
Page 2: ......
Page 6: ......
Page 20: ...PCMCIA Fast Ethernet card user s manual 14 N NO OT TE ES S ...
Page 59: ...PCMCIA Fast Ethernet card user s manual 53 N NO OT TE ES S ...
