Access Point
Ver1.1
User’s Manual
30/08/2001
16
User Community: Indicates the user’s password. The default pasword is “pulic”
User Access: Indicates the user’s access rights. The user can only read and not set or change the AP’s
parameters.
Administrator Community: Indicates the administrator’s password. The default password is “public”
Administrator Access: Indicates the Administrator’s access rights. The administrator can read and also set or
save changes to the AP’s parameters.
Manufacturer Community: Indicates the manufacturer’s password.
Manufacturer Access: Indicates the manufacturer’s access rights. The manufacturer can read and set or
save changes to the AP’s parameters. Also can view or modify the Hardware Configuration.
Gateway IP Address: Network Gateway
IP Filtering: Enable/Disable the possibility to allow only IP protocol packets to pass through the WLAN and
any other protocol packets filtered out.
DHCP client: Enable/Disable automatic IP adress assigment by the DHCP server Primary Port: Determines
the Access Point;s MAC and IP Address.
Primary Port: The interface which determines the DHCP server (EthernetPort/Wireless Port).
Authorization Algorithm: Enable/Disable the association with authorized MAC Addresses stations.
SNMP traps: Enabled/Disabled SNMP traps, which are the messages indicating the actions related to the AP
that have taken place.
Preferred BSSID: Remote MAC Address for connection, in Access Point Client or Wireless Bridge
Operational modes.
WEP 128 keys #1-#4: The default key that will be used. May be edited if WEP type is 128 bits.
5. CR31
Settings: By selecting the “C31 Settings” option, you can get or set the Transmitting Power values for
the Control Register 31 of the Base-band, for each channel.