37
Internal call forwarding
Gigaset 4170/4175isdn, A31008-G4170-B100-2-7619
Komfortabel.fm
21.2.02
Step
by
Step
Internal call forwarding
Configuring a forwarding destination
Press
G
for selection menus.
Select using [
Á
] and [OK]:
Base Settings
→
Int. call forw.
→
Forward. dest.
→
(required internal subscriber)
.
Only one forwarding destination can be selected for internal call forwarding.
Activating/deactivating internal call forwarding
Internal call forwarding can only be activated if a forwarding destination
extension has been configured.
Press
G
for selection menus.
Select using [
Á
] and [OK]:
Base Settings
→
Int. call forw.
→
Activate?
or
Deactivate?
Defining the number of ring cycles
Ring delay is used to define the number of ring cycles to be completed before
a call is forwarded. Between 0 to 9 ring cycles can be configured.
Press
G
for selection menus.
Select using [
Á
] and [OK]:
Base Settings
→
Int. call forw.
→
No. of rings
.
Enter the number of ring cycles and confirm with [OK].
External call forwarding - CF
If call forwarding is configured, it is activated at the provider exchange. Both
telephone lines assigned to your ISDN connection are free during call
forwarding. You must pay the connection costs together with a surcharge. You
can define the following conditions for call forwarding:
Immediately — On busy — On no reply
Configuring a new call forwarding destination
Press
G
for selection menus.
Select using [
Á
] and [OK]:
Base Settings
→
Ext. call forw.
Press [
W
] to select:
New entry
→
(MSN for which
call forwarding should apply)
→
Immediately, On busy
or
On no reply
.
Enter the required destination call number and confirm with [
W
].
Select using [
Á
] and [OK]:
Save entry
.
Confirm the prompt with [YES]: Call forwarding is activated.
or
Confirm the prompt with [NO]: Call forwarding is not activated.
Activating/deactivating external call forwarding
Press
G
for selection menus.
Select using [
Á
] and [OK]:
Base Settings
→
Ext. call forw.
Select using [
Á
] and [
W
]:
(required call forwarding)
.
Select using [
Á
] and [OK]:
Activate?
or
Deactivate?
1.
2.
1.
2.
1.
2.
3.
1.
2.
3.
4.
5.
6.
6.
1.
2.
3.
4.
