15
Gigaset A116 / LUG GR-MEA-International en / A31008-M2801-R101-1-8N19 / appendix_legal.fm / 7/27/16
Te
mplat
e
G
o
, V
e
rs
ion 1
, 01.
07
.2
014
/ M
odu
leV
e
rs
ion 1
.0
Appendix
Appendix
Customer service & assistance
If you have any further questions, your phone retailer will be happy to assist.
Authorisation
This device is intended for analogue phone lines in your network.
Country-specific requirements have been taken into consideration.
Hereby, Gigaset Communications GmbH declares that the radio equipment type Gigaset A116
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
This declaration could also be available in the "International Declarations of Conformity" or
“European Declarations of Conformity” files.
Therefore please check all of these files.
Environment
Environmental management system
Gigaset Communications GmbH is certified pursuant to the international standards
ISO 14001 and ISO 9001.
ISO 14001 (Environment):
Certified since September 2007 by TÜV SÜD Management
Service GmbH.
ISO 9001 (Quality):
Certified since 17/02/1994 by TÜV SÜD Management Service GmbH.
Problem
Cause
Solution
Nothing on the
display.
The handset is not switched on. Press the End call key
for
about 5 seconds
or place the handset
into the base.
The batteries are empty.
Charge or replace the batteries.
No wireless
connection to the
base,
Base
flashes
on the display.
The handset is outside the
range of the base.
Move the handset closer to the base.
The base is not switched on.
Check the mains plug on the base
You cannot hear a
ring or dial tone
from the fixed line
network.
The phone cable supplied has
not been used or it has been
replaced by a new cable with
the wrong pin connections.
Please always use the telephone cable
supplied or ensure that the pin
connections are correct when
purchasing from a retailer.: 3-4
assignment of phone wires /
EURO CTR37.
