Te
mplat
e
M
odu
le
, V
e
rs
ion 1.
3,
1
1
.04.
20
19,
Phone settings
Gigaset CL390HX / LHSG IE-UK-International en / A31008-M2962-R101-1-4N19 / settings_HX.fm / 9/9/19
34
Availability and operation of the functions
may differ on your telephone.
Resetting the base
(depending on the base)
A reset disables mode
No Radiation
, resets individual settings and deletes all lists.
The system PIN is reset to the original code
0000
.
The time and date are not affected. The answer machine (if available) is not ready until after
about 15 seconds after the base is reset.
Resetting the base from the menu
The handsets remain registered. The system PIN is
not
reset.
¤
Menu
Settings
OK
System
OK
Reset Base
OK
. . .
Reset?
OK
Resetting the base using a key on the base
All handsets are de-registered. The system PIN is set back to the original code
0000
.
¤
Remove the power cable from the base
Keep pressed the
Registration/paging key
on the
base
At the same time, reconnect the power cable to the base
Keep the key pressed
for at least another 5 seconds
Firmware update
(depending on the base)
The handset supports firmware updating via the DECT radio link to the base/router (SUOTA =
Software Update Over The Air).
Automatically check whether there is new firmware:
If new firmware is available for the handset, a message to this effect is displayed.
¤
Start the firmware update with
OK
.
The base/router to which the handset is registered must also support this function and
be connected to the Internet
¤
Menu
Settings
OK
Firmware Update
OK
Showing the current firmware version:
¤
Current Version
OK
Updating firmware:
¤
Update
OK
. . . If there is new firmware, the update
is started
The update process may take up to 30 minutes. During this time, only restricted
handset use is available.
¤
Menu
Settings
OK
Firmware Update
Automatic Check
OK
(
= enabled)