6
First steps
Gigaset SL560 / EN for Greece / A31008-M1710-T111-2-8U19 / starting.fm / 22.10.08
Reception strength:
The display shows the quality of the radio
contact between the base station and
handset:
u
Good to poor:
Ð i Ñ Ò
,
u
No reception:
|
flashes.
Connecting the base station
¤
First
connect the mains adapter and
then
the phone jack as shown below-
and place the cables in the cable
recesses.
1 Underside of the base station (detailed
view)
2 Mains adapter 230 V
3 Phone jack with phone cord
Please note:
u
The mains adapter must be
always
connected
, as the phone will not oper-
ate without mains connection.
u
If you buy a replacement phone cord
from a store, ensure that the phone
jack is connected correctly.
Setting up the handset for use
The display is protected by
a plastic film.
Please
remove the protective
film!
Fitting the battery pack
¤
Insert the battery pack at an angle from
the left introducing the lugs into the
cavity first.
¤
Then push the casing from the top,
until the retaining clip on the side of
the battery pack clicks securely into
place in the casing.
Please note:
You must press the retaining clips down in
order to remove the battery pack.
Correct phone jack assignment
1 unused
2 unused
3 a
4 b
5 unused
6 unused
1
3
2
1
1
1
3
2
1
4
5
6
Caution:
Use only the rechargeable Gigaset Communi-
cations GmbH * Original battery pack
(page 53). Never use a conventional (non-
rechargeable) battery pack, as this may cause
significant damage to health and property. For
example, the outer casing of the battery pack
could be destroyed or the battery pack could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.
Summary of Contents for Gigaset SL560
Page 69: ......