5
6
7
8
Authorized Service Facility; (c) consumables such as fuses or batteries; (d) ordinary wear
and tear or cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs of
product removal, installation, set-up service, adjustment or reinstallation; and (g) claims
by persons other than the original purchaser.
Should a problem occur that is covered by this warranty, take the product and the sales
receipt as proof of purchase date to the place of purchase. Ignition L.P. will, at its option,
unless otherwise provided by law: (a) repair the product without charge for parts and
labor; (b) replace the product with the same or a comparable product; or (c) refund the
purchase price. All replaced parts and products, and products on which a refund is made,
become the property of Ignition L.P. New or reconditioned parts and products may be
used in the performance of warranty service. Repaired or replaced parts and products
are warranted for the remainder of the original warranty period. You will be charged for
repair or replacement of the product made after the expiration of the warranty period.
IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS NOT
STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE
IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY
AND, IF APPLICABLE, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR
PURPOSE, SHALL EXPIRE ON THE EXPIRATION OF THE STATED WARRANTY
PERIOD.
EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY OR
RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY OTHER PERSON OR
ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR
INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY
BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES
RESULTING FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY,
REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUEN-
TIAL DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES.
Some States do not allow limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you. This warranty gives you specific legal rights, and you
may also have other rights which vary from State to State.
You may contact Ignition L.P. at:
Ignition L.P., 3102 Maple Ave Suite 450, Dallas, TX 75201
02/09
For product support, call
1-866-315-0426.
Protect the environment by recycling used electronics. Go to
E-CyclingCentral.com to find an electronic recycling center near you.
Printed
in China
12A09
25-421
© 2009. Ignition L.P. All rights reserved. Gigaware
is a registered trademark used by Ignition L.P.
Press the enclosure
vertically into the stand.
n
Notes:
• Plug the adapter into an easily accessible power outlet
located near the equipment.
• The power source must supply 12V DC and deliver at least
1500mA. Its center tip must be set to positive and its plug
must fit the
DC12V
jack.
• Using an adapter that does not meet these specifications
could damage the hard drive enclosure or adapter.
Technical Support
If you have any questions about your hard drive enclosure,
contact Technical Support for assistance at:
Toll Free Number: (866) 413-7462
Technical Support Hours: Monday to Friday,
9 a.m. to 6 p.m. (Pacific Standard time.)
E-mail Address: support@gigawarehd.com
The Technical Support department will respond to your
enquiries within 24 hours.
Specifications
Data Transfer Rate....................................................................................480 Mb/S
AC Adapter............................................................ Input: 100–240V, 50/60Hz, 0.4A
..................................................................................................... Output: 12V/1.5A
4
Insert in Stand
USB Cable Length .........................................................................3.28 ft. (100 cm)
Support IDE Hard Drive ............................................Seagate, Hitachi, WD, Maxtor
Dimensions (H×W×D) ....................................................4.92 × 8.07 × 1.34 Inches
...............................................................................................(125 × 205 × 34 mm)
Enclosure Weight ........................................................................... 13.76 oz (390 g)
Specifications are subject to change and improvement without notice. Actual
product may vary from the images found in this document.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Ignition L.P. may cause interference
and void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Limited Warranty
Ignition L.P. warrants this product against defects in materials and workmanship under
normal use by the original purchaser for
one (1) year
after the date of purchase. IGNI-
TION L.P. MAKES NO OTHER EXPRESS WARRANTIES.
This warranty does not cover: (a) damage or failure caused by or attributable to abuse,
misuse, failure to follow instructions, improper installation or maintenance, alteration,
accident, Acts of God (such as floods or lightning), or excess voltage or current; (b)
improper or incorrectly performed repairs by persons who are not a Ignition L.P.
Windows is a registered trademark and Windows Vista is a trademark of
Microsoft Corporation in the United States and/or other countries.
Mac is a trademark of Apple Inc., registered in the U.S. and other countries.
Product
3.5” SATA Hard Drive Enclosure
Model
25-421
Responsible
Party
Ignition L.P.
3102 Maple Ave Suite 450
Dallas, TX 75201
Phone
866-315-0426
2
Connect to Your Computer
1.
Plug the small end of the USB plug into the mini USB port
on the enclosure.
2.
Plug the large black USB plug to the computer’s USB port.
3.
Plug the AC adapter’s barrel plug into the
DC 12V
jack,
then plug the other end into a standard AC outlet.
3
Turn the Hard Drive On
Press
ON/OFF
to
ON
to turn on the hard drive.
n
Note:
Do not disconnect device during transfer.
Indicator Light
• Lights blue when powered on
• Flashes during data transfer
3502-T41000-0A
