Gilbarco Advantage K35496, Introduction Manual

Assembling the Panels [T17232-GXXX (The Advantage Series Only)]

Page 6

MDE-2636D Canopy Kits (K35496 and K35498) for The Advantage® Series and Canopy Kit (K96632-02) for Encore® · September 2012

Assembling the Panels [T17232-GXXX (The Advantage 
Series Only)]

The Assembling Panels (T17232-GXXX) are as shown in 

Figure 1

.

Figure 1: Assembling the Panels (T17232-GXXX)

Panels



(T17232-GXXX)

Flat Washer (M00959B010)

Hex Bolt (M01115B004)

Flat Washer (M00959B010)

Lock Washer (M01020B001)

Hex Nut



(M01114B004)

To assemble the four major panels (T17232-GXXX), proceed as follows: 

Note: Before assembling, check the panel graphics for proper positioning.

1

Position the end panel and side panel so that the three holes in each corner are aligned.

Note: Use the truck bed as a work table and assemble by placing either the short panel flat 

and installing the long panels from 

Figure 1

.

2

Place the Flat Washer (M00959B010) on the Hex Bolt (M01115B004), and then insert the 



Hex Bolt (M01115B004) as shown in 

Figure 1

 through one of the three pairs of aligned holes 

in both the Panels.

Note: Use the needle nose pliers to hold the Hex Bolt (M01115B004) and Washer 

(M00959B010).

3

Fasten and secure the Hex Bolt (M01115B004) by installing in the following order:

• Flat Washer (M00959B010)
• Lock Washer (M01020B001)
• Hex Nut (M01114B004)

4

Repeat for each of the three holes at all four corners of the assembly.